Star Headlight & Lantern C2 LED BEACON - Manual (Page 3)

-2-
Wiring Instructions
Pattern Programming
Patterns
Flash Pattern Shortcuts
Hold Pattern Select Button or
Touch Green Wire to Ground Light Flashes Pattern Becomes
3 seconds 1 Flash Pattern 1 - Slow Singleflash
6 seconds 2 Flashes Pattern 10 - Fast Quadflash
9 seconds 3 Flashes Pattern 21 - Fast Quadflash w/Post Pop,
Tripleflash, Flicker
Note: After programming the flash pattern, cut short and tape or cap off the Green wire
so that it does not come into contact with ground or power.
14. Flicker
15. Delta Omega
16. Flicker-Flash
17. Super Combo/Mix Pattern
18. Fast Doubleflash, Flicker
19. Slow Doubleflash, Quadflash w/Post Pop
20. Slow Double, Quint x2, Flicker, Dual Quad w/Post Pop
21. Flicker, Tripleflash, Quadflash w/Post Pop
22. Delta Omega, Flicker, Slow Doubleflash
23. Medium Singleflash †
24. Medium Singleflash, Fast Singleflash
25. Cycle all patterns
26. Steady On
† SAE Class 2 Approved Patterns when properly configured
1. Slow Singleflash †
2. Fast Singleflash †
3. Superfast Singleflash
4. Beacon Fade
5. Pre Pops
6. Slow Doubleflash †
7. Fast Doubleflash †
8. Tripleflash †
9. Pre-Pop Tripleflash †
10. Quadflash † (DEFAULT)
11. Fast Quadflash w/Post Pop †
12. Quintflash †
13. Pre-Pop Quintflash †
Depending upon your model, pressing the pattern select button on the
cig plug, or touching the green wire to ground on hard-wired models, will
allow you to change the flash pattern.
The unit has 28 patterns to choose from. After the final pattern is
reached, the patterns will cycle through again. The UNIT will remember
the pattern it was in when turned off and display the same pattern when
re-activated.
B
L
A
C
K
RED: Power
GOOD
CHASSIS
GROUND
5 AMP
FUSE
CONNECT
TO +12 VDC
SWITCH
GREEN: Pattern Select - Touch and release to Ground
CAUTION: All of our DC powered warning lights are polarity
sensitive. These lights are polarity protected only if the
appropriate fuse is used. All wires connected to the
positive terminal of the battery should be fused at the
battery for their rated load. Testing the light before
this fuse is properly installed will void the warranty
on the light.