Star Headlight & Lantern 201ZL Series - Manual (Page 4)

-3-
Patterns
15. Delta Omega
16. Flicker-Flash
17. Super Combo/Mix Pattern
18. Slow Singleflash, Flicker
19. Fast Doubleflash, Fast Quadflash w/Post Pop Mix
20. Dual Quad w/Post Pop, Double, Quint, Quint, Flicker
21. Fast Quadflash w/Post Pop, Tripleflash, Flicker
22. Delta Omega, Flicker, Doubleflash
23. Medium Singleflash †
24. Medium Singleflash, Fast Singleflash †
25. Cycle all patterns
26. Steady On
27. Steady On (Low Power)
28.
Medium Singleflash †
† SAE Class 3 Approved Patterns when properly configured
1. Slow Singleflash
2. Fast Singleflash
3. Superfast Singleflash
4. Beacon Fade
5. Pre Pops
6. Fast Doubleflash
7. Superfast Doubleflash
8. Fast Tripleflash
9. Fast Pre-Pop Tripleflash
10. Fast Quadflash (DEFAULT)
11. Fast Quadflash w/Post Pop
12. Quintflash
13. Pre-Pop Quintflash
14. Flicker
Depending upon your model, pressing the pattern select button on the
cig plug, or touching the green wire to ground on hard-wired models, will
allow you to program the desired flash pattern.
The unit has 28 patterns to choose from. After the final pattern is
reached, the patterns will cycle through again. The UNIT will remember
the pattern it was in when turned off and display the same pattern when
re-activated.
Pattern Selection
If you have any questions concerning this or any other product,
please contact our Customer Service Department at (585) 226-9787.
If a product must be returned for any reason, please call the Customer Service
number listed above and ask for the Repair Department to obtain a Returned
Material Authorization number (RMA #) before you ship the product back. Please
write the RMA # clearly on the package near the mailing label.
For ease of navigation there are some patterns that you can skip to by holding the green
wire to ground (or pressing the Pattern Select button for mag mount models) for a multiple of
3 seconds, and then releasing it. For example, if at anytime you would like to go directly to
Pattern 1 (Slow Singleflash), simply touch the Pattern Select wire to ground for 3 seconds.
The LEDs should turn off when the green wire is connected to ground, then after 3 seconds,
the LED will flash once. Remove green wire form ground and the light will be in the Slow
Warn pattern.
Flash Pattern Shortcuts
Hold Pattern Select Button or
Touch Green Wire to Ground Light Flashes Pattern Becomes
3 seconds 1 Flash Pattern 1 - Slow Singleflash
6 seconds 2 Flashes Pattern 10 - Fast Quadflash
9 seconds 3 Flashes Pattern 21 - Fast Quadflash w/Post Pop,
Tripleflash, Flicker
Note: After programming the flash pattern, cut short and tape or cap off the Green wire
so that it does not come into contact with ground or power.