Star Headlight & Lantern 7400 Laser M - Manual (Page 3)

-1-
11-Wire Harness (271-PHANTOM)
Black Ground (Connect to the negative side of the battery)
Red Power for ALL components (MUST be connected to constant +12VDC † )
Orange Front Enable (+12VDC Turns on Front Facing M-Tech Plus™ Lights) *
Brown Rear Enable (+12VDCTurns on Rear Facing M-Tech Plus™ Lights) *
Red w/Green
Driver Side Pattern Select (Touch and release to +12 VDC to change patterns)
Pursuit Lights Pattern Select (Touch and release to +12 VDC to change patterns)
Green Passenger Side Pattern Select (Touch and release to +12 VDC to change patterns)
White Right Alley or Right Turn/Brake Light (Activated by +12VDC) or Sync
Purple Left Alley or Left Turn/Brake Light (Activated by +12VDC) or High/Low Control (see page 5)
Bare Ground (Shield - Connect to a good chassis ground)
Green w/Yellow Takedown or Work Lights (Activated by +12VDC) or Driver Side Scene Lights
White w/Brown
Pursuit Function/Flashing Alley or Marker Lights (Activated by +12VDC) or Passenger
Side Scene Lights
QUICK-INSTALL WIRING GUIDE
WIRE COLORS AND FUNCTIONS WILL VARY FROM HARNESS TO
HARNESS. PLEASE BE SURE TO CORRECTLY IDENTIFY YOUR
HARNESS AND USE THE CORRESPONDING TABLE. IN ADDITION, ALL
LIGHTBARS ARE SHIPPED WITH A WORKSHEET THAT IDENTIFIES THE
FUNCTION FOR EACH WIRE COLOR IN THAT SPECIFIC LIGHTBAR.
!
Please Note: ONLY the M-Tech Plus heads are +12-24VDC. All other components are +12VDC only.
* - The Front Enable and Rear Enable options are NOT available on Amber Value Lightbars.
† - The Red wire MUST be connected to +12VDC for the front and rear warning LEDs to operate. If you
are NOT utilizing a separate Front and Rear enable function, you may connect the Red wire, along
with the Front enable wire and Rear Enable wire to +12-24VDC through your On/Off switch. If you
ARE using a separate Front and Rear Enable function, connect the Red wire to constant +12-24VDC.
Please note: When the red POWER wire is connected to constant power the light will draw a small
current (20 mA). If your vehicle will be sitting for extended periods of time (i.e. more than a few
days), it is recommended all power wires be routed through an ignition switched power source.
14-Wire Harness Wiring (271-TOWBAR)
Light Blue Optional - High/Low (Ground for low intensity)
Orange Rear Enable (Turns on Rear Facing M-Tech Plus™ Lights) *
Yellow Left Stop (+12VDC Only - Used only if you have STT lights in your bar)
Green Right Stop (+12VDC Only - Used only if you have STT lights in your bar)
White w/Orange Work Lights (+12VDC Only - Used only if you have worklights in your bar)
Brown Tail (+12VDC Only - Used only if I.D. or STT lights are in your bar)
Red Power (Connect to constant +12-24 VDC † )
Red w/White Scene Lights
Red w/Green Passenger Side Pattern Select (Touch and release to +12-24 VDC to change patterns)
Black w/Green
Driver Side Pattern Select (Touch and release to +12-24 VDC to
change patterns)
White w/Green Front Enable (Turns on Front Facing M-Tech Plus™ Lights) *
Gray Synchronization (Used to synchronize two or more lights together)
Black Ground (Connect to the negative side of the battery)
Bare Ground (Shield - Connect to a good chassis ground)