Star Headlight & Lantern 9500 Series - 58" Warning Package - Manual (Page 9)

-7-
(Pictured above is one example of a bar with 8 linear strobe heads)
Three wires in your cable harness control the strobe power supplies and the strobe heads
connected to them. The functions of those wires are as follows:
Connect to +12VDC
Red - Front Linear Strobe Heads On/Off
Red w/Black Stripe - Rear Linear Strobe Heads On/Off
Touch and release to +12VDC
Red w/Green Stripe - Pattern Select
Note: Heads #1 & #4 will flash together alternating with #2 & #3.
Activating All Strobe Heads Together
(MOST APPLICATIONS)
To turn on all eight heads
connected to both power
supplies together, connect the
Red and Red w/Black Stripe
wires together through your
On/Off switch. When the
switch is thrown, all of your
strobes will flash. (#1 & #4 will
alternate with #2 & #3)
Proceed to the Pattern
Selection section on page 10
to program the flash pattern of
your strobe packs.
Activating Front and Rear Strobes Separately
To turn on your front strobe
separately from your rear
strobes, connect the Red and
Red w/Black Stripe wires
through two separate
switches. When one switch is
thrown, only the front strobes
will flash. (#1 & #4 will
alternate with #2 & #3). When
the other switch is thrown the
rear strobes will flash.
Proceed to the Pattern Selection
section on page 10 to program
the flash pattern of your strobe
pack.
Lightbars with Eight Linear Strobe Heads
2A
1B
1A
4B
4A
3B
PACK A
2B
PACK B
Touch and Release To
+12VDC to Change Pattern Red w/Green
DO NOT PERMANENTLY
CONNECT Red w/Green
Stripe TO +12VDC!!!
!
H
a
rn
e
s
s
fr
o
m
L
ig
h
tb
a
r
Red w/Black
Red
20 Amp
On/Off
SWITCH CONNECT
TO +12 VDC
H
a
rn
e
s
s
fr
o
m
L
ig
h
tb
a
r
Red w/Black
Red w/Green
Red
Front Strobes
On/Off Switch
Rear Strobes
On/Off Switch
CONNECT
TO +12 VDC
Touch and Release To
+12VDC to Change Pattern
CONNECT
TO +12 VDC
!
DO NOT PERMANENTLY
CONNECT Red w/Green
Stripe TO +12VDC!!!