Star Headlight & Lantern Hide-A-STA In-Line Remote Flashing LED Kits - Manual (Page 3)

-1-
Proper installation of the unit is essential for years of safe, reliable operation. Please read
all instruction before installing the unit. Failure to follow these instructions can cause
serious damage to the unit or vehicle and may void warranties.
• The installer must have a firm knowledge of basic electricity, vehicle electrical systems,
and emergency equipment.
• If you need to drill any holes when installing this product, please take care to check that
BOTH SIDES of your drilling surface are clear from obstructions, to ensure that you do
not damage your vehicle and or pre-existing wiring.
• Controls should be placed within convenient reach of the driver.
Before beginning the installation:
• Determine where the heads are to be mounted.
• Determine where you will mount the switch.
• Determine if you will be synchronizing your flasher with any other flashers or other
synchronizable products.
• Verify that you have a clear path to run your wires between the heads, flasher unit(s), switch,
and any other lights that the flasher will be synchronized with.
Keep These Instructions - Keep these instructions in the vehicle or other safe place for
future reference. Advise the vehicle operator of the location.
Please Note: These instructions are provided as a general guideline only. Some
vehicles may require special mounting, wiring, and/or weather-sealing. This is the
sole responsibility of the installer. Star Headlight & Lantern Co., Inc. assumes no
responsibility for the integrity of the installation for this or any of its products.
Installation Notes
IMPORTANT
• Each LED head has its own in-line flasher.
• The LED light heads must be installed inside an existing light assembly on the vehicle.
• The unidirectional light head on the LDHF301 must be installed vertically to ensure proper light
distribution.
• The spherical light head on the LDHF311 can be installed in any direction.
• The unidirectional light heads on the LDHF301 should only be installed in a 1” hole on a top or
bottom surface that allows the base of the head to be horizontal.
• Both the unidirectional and spherical heads should have 3” diameter total clearance inside the
housing (allows 1” clearance on all sides of the head).
• The in-line flasher should be secured to the vehicle so that it does not pull on any of the wires.