Star Headlight & Lantern STAR-PA RP310Q - Manual (Page 3)

-1-
Mounting
• IMPORTANT: Please read all of the following instructions before installing your new
strobe system. This instruction sheet applies only to the models listed.
•
CAUTION: All of our remote power supplies are polarity sensitive. They are polarity
protected only if the appropriate fuse is used. All wires connected to the positive
terminal of the battery should be fused at the battery for their rated load. Testing the
system before this fuse is properly installed will void the warranty on the light.
• Opening or tampering with your remote power supply will void the warranty.
The remote power supply must be mounted against a smooth metal surface in a dry
location. Water damage to the power supply will also void the warranty. Typical
mounting locations of your power supply include the interior firewall, beneath the seat
of a truck, or inside a large toolbox.
Mount the pack on a smooth metal surface to allow for adequate heat dissipation. Do not mount
the pack near any external heat source, as this will retard its ability to dissipate heat sufficiently.
Mount the Pack using four bolts (not included). When mounting, make sure a good electrical
connection exists between the mounting plate and the vehicle chassis. This will help to eliminate
any RF interference.
When mounting the power pack and accessories, please be sure to keep
any radio frequency sensitive equipment at least 20” from the power pack,
cables, and/or wires which make up your strobe system. The pack has
been designed to limit RFI emissions, but certain very sensitive equipment
may still be affected. Symptoms may include, but are not limited to,
sporadic operation and degraded performance. Star Headlight & Lantern
Co., Inc. cannot assume any responsibility for any radio frequency induced
malfunction or damage to any radios, sirens, lightbars, or any other
equipment mounted within 20” of this strobe system. Any antennae
mounted in the proximity of the system may cause your radio to suffer the
aforementioned results.
RP310 SERIES
1 1
4
"
1 1
4
"
4 1
2
"
1
4
" DIA.
6 3
4
"
6"
5"