Star Headlight & Lantern RSK310P Strobe Kit - Manual (Page 9)

REV. H 11/5/04 PLITSTR119
WIRING INSTRUCTIONS FOR STAR SWITCH #SP3860-2H
(ON/OFF)(HI/LO) Switches
1. IMPORTANT:
Please read all of
the following
instructions before
installing your new
Star switch. This
instruction sheet
applies only to the
model listed at the
top of this sheet.
2. CAUTION: All of our DC powered warning lights are polarity sensitive.
These lights are polarity protected only if the appropriate fuse is used. All
wires connected to the positive terminal of the battery should be fused at
the battery for their rated load, in addition to the fuse provided at the
switch panel. Testing the light before this fuse is properly installed
will void the warranty on the switch and light.
3. The black wire from terminal 3 of SW1 is the ground lead and should be
connected to a good chassis ground.
4. Connect the fused red wire from terminal 1 of SW1 to the positive side of
the 12VDC power through an appropriate fuse based upon the current
draw of the light you are installing. Check the label on the warning light
for proper voltage and current.
5. Connect the red wire from terminal 2 of SW1 to the red wire from your
strobe light or Star Pak.
6. Connect the purple wire from terminal 2 of SW2 to the purple (or white)
wire from your strobe.
7. When properly installed, SW1 will be on the left side of the switch panel
(front view) and turn your strobe light on and off, and SW2 will be on the
right (front view) and switch between HI and LO power.
If you have any questions concerning this or any other Star product,
please contact our Customer Service Department at (585) 226-9787.
3 3
LOW
SW2
GOOD
CHASSIS
GROUND
PURPLE
PURPLE
WARNING
LIGHT
BLACK
RED
CONNECT RED FUSED LEAD TO +12 VDC
GOOD
CHASSIS
GROUND
RED
10 AMP
FUSE
SW1
OFF
1
2
1
2
BLACK
HIGH
SP3860-2H SWITCH PANEL (REAR VIEW)
ON
Please Note:
For the SP3860-2H-15, the 10
amp fuse will be replaced with
a 15 amp fuse.