Star Headlight & Lantern 9200HL Series Star Halo LED - Manual (Page 4)

-3-
Synchronization of Multiple Lights
T
IM
E P
h
a
s e
2
P
h
a
s e
2
P
h a
s
e 1
C
y c
le
2
P
h a
s e
1
C
y c
le
1
(OFF)
(ON) (OFF) (ON)
Synchronized Head Programmed for Phase 1
2 Complete flash cycles shown
Synchronized Head Programmed for Phase 2
2 Complete flash cycles shown
(Permanent Mount Versions Only)
You can synchronize up to six total approved lights.
If you will be synchronizing two or more units together, leave the white wires
disconnected until programming for each has been completed. Connect the
white wires from the units together ONLY AFTER PROGRAMMING them
all for the same Pattern Type (Phase MAY differ).
If you will be synchronizing your light with any of our products, please note the
following:
• All units that are to be synchronized MUST have the same Pattern Type.
• To check pattern compatibility with other “S-Link” products, review the Pattern List for each
product, noting the Pattern Type. Certain patterns are compatible with some lights, but not
compatible with others.
• Although the programmable Flash Patterns can vary between our different lights, Pattern
Types F, G, H, I, & J are fully compatible patterns with ALL of our other “S-Link” products.
Please Note: Most of our compatible products have patterns that can be
programmed for Phase 1 or Phase 2. One side of the 9200 HALO minibar flashes
in Phase 1, while the other flashes in Phase 2. When synchronizing any other
light (excluding 9200 HALO), the Phase of the additional light being
synchronized will determine which half of the minibar the additional light flashes in
conjunction with.
1. Review the Pattern List for each synchronized product, noting the Pattern Type for each
product.
2. Select a Pattern Type that is compatible with all of the lights/flashers you will be synchronizing.
3. Program each light according to the instructions enclosed with each. For lights that have
patterns with a Phase: All lights programmed for the same Phase will flash ON and OFF at
the same time (flash simultaneously). Lights that are programmed for different phases will flash
opposite one another (alternate).
4. After you have the correct patterns programmed for ALL of the lights you wish to
synchronize, turn all of the lights off and connect the white wires from all units together.
5. Power all of the lights up at the exact same time to verify they are flashing in the desired
pattern. Power MUST be applied to all synchronized lights simultaneously.
Excessive switch bounce or attempting to power the units up independently will
result in erratic operation.