Star Headlight & Lantern ULB9S Star Mini-Phantom Undercover - Manual (Page 7)

-7-
(hardwired version only)
The ULB9-1 (hard wire) should be wired through a 5 amp fuse (not supplied) and a 12VDC
switch (not supplied) capable of handling at least 5 amps. Connect the wires as follows:
Black - Good Chassis Ground
Red - Power (+12 VDC)
White - Synchro: AFTER PROGRAMMING, Connect the white wires from the two lights
together to synchronize them together.
Green - Pattern Select: Touch and release to Ground to scroll through the
patterns. The light will cycle back to the first pattern
after pattern #24.
ULB9-1 and ULB9S-1 Wiring and Operation
FOR SYNCHRONIZATION BOTH LIGHTS MUST BE SET FOR THE SAME PATTERN TYPE!
SPLIT/SINGLE MODES
For single-colored lights, the entire light flashes together. For dual-colored lights, the two
halves of the light alternate. If you would like to change this setting for either style, proceed
as follows:
• Connect Black to Ground
• Connect Red and White to power
• Hold the green wire to Ground and release it when the light flashes 4 times.
• After an additional second, release the white wire.
This procedure will toggle the Split/Single mode.
Light 1 Light 2
(Programmed for same Phase)
Light 1
T
IM
E
(Programmed for opposite Phases)
Light 2
(Phase 1) (Phase 2)
White Wires
(Phase 1) (Phase 1)
White Wires
(OFF) (ON)
White Wires
(OFF) (ON)
(ON) (ON)
White Wires
(OFF) (OFF)
SYNCHRONIZATION
You can synchronize up to six lights
with compatibility.
DO NOT CONNECT WHITE WIRES
UNTIL PROGRAMMING HAS BEEN
COMPLETED FOR ALL LIGHTS!!
1. Power up the first unit and select
a Phase 1 pattern. Touch and
release the green wire to ground
to change patterns.
2. Program the second light
with the same Pattern Type.
Lights with the SAME phase
flash together
(simultaneous).
Lights with DIFFERENT
phases flash opposite one
another (alternate).
3. After programming all lights,
tie off the green wires and
connect the white wires
together.
4. Test lights by applying power
to all of them at the same time.
Phase 1
Flash
Pattern
Phase 2
Flash
Pattern
Pattern
Type
Pattern Description
Shortcut
1 13 K Flicker
Pattern 1 (Phase 1) :
3 sec or 1 flash
Pattern 13 (Phase 2) :
9 sec or 3 flashes
2 14 L Fast Doubleflash
3 15 M Tripleflash
4 16 N PSU Flicker
5 17 O PSU Random
6 18 F Quadflash †
Pattern 6 (Phase 1) :
6 Sec or 2 flash
Pattern 18 (Phase 2) :
12 sec or 4 flashes
7 19 G Quadflash w/Post-Pop †
8 20 H Singleflash †
9 21 I Doubleflash †
10 22 J Variable AKA Delta-Omega
11 23 C Post Pop
12 24 E Random
NA Steady 18Sec
† - SAE J595 and California Title 13 approved patterns
Pattern Shortcuts: Hold Green wire to ground for indicated time.
Split Mode Phases: One side flashes in Phase 1, the other
side flashes in Phase 2
Steady Burn: Not in pattern cycle. Only accessible through
shortcut. Hold Green wire to ground for 18
seconds (light will flash 6 times).