Star Headlight & Lantern ULB21 Star Split-Phantom Undercover - Manual (Page 4)

-4-
Bracket used with
either mount
These mounting instructions describe the standard, most common way to mount this light.
This method may or may not apply to your vehicle. Because vehicles can vary widely in
their design, it may be necessary to configure the brackets differently than described.
Some applications may require you to design your own custom brackets. The installer
assumes all responsibility for the integrity of the installation.
1. Use the #6-5/8” black screw to attach the angled bracket to the holes in the end of the
light, as pictured below. Use the rubber washer between the bracket and the light
housing. Repeat for the other half if installing the 274-ULB21-U1.
CAUTION: Take extreme caution not to over tighten the
screws!!! Over tightening of the screws can
strip the holes and result in a faulty mount.
Suction Cups or Window Adhesive Mounting (MANDATORY)
You MUST use either the suction cups or the window adhesive mounts in addition to the
forked brackets.
2. Use the appropriate hardware (as shown above and on page 1) to attach either the
Adhesive Pads or the Suction Cups, depending upon your application.
If using the window adhesive, carefully follow the directions on the packaging.
The manufacturer assumes no responsibility for the secure
mounting of this light. It is the responsibility of the installer
and/or owner to ensure the lightbar is mounted securely.
Check your light every time you enter the vehicle to ensure
that it is mounted securely.