Star Headlight & Lantern ULB42 The Star Phantom Undercover - Manual (Page 6)

-5-
Operating Instructions
Electrical Connections
1. After the light is secured, route your cord to your ON/OFF switch (not provided). If
you need a switch, you may order Star part #SP3860-1 lighted ON/OFF rocker
switch.
2. Connect the black wire from the cable to the negative terminal of your battery
(preferred) or a good chassis ground.
3. Connect the white wire to +12VDC through a 10A fused ON/OFF switch.
1. The ULB42-1 rear window Star Phantom® is designed for simple
operation. This unit has only a Pattern Select Button.
2. This is a momentary switch. Each time this switch-button is depressed while
The Star Phantom® is activated, it will cycle to the next pattern. The
Star Phantom® is designed with thirty-five different patterns, listed on the
following page.
Indicator LED
Located on the bottom of the Star Phantom is an Indicator LED. When
your light is activated in any mode, this LED will light up.
All wires connected to the positive terminal of the battery should be fused at the
battery for their rated load. Testing the light before this fuse is properly
installed will void the warranty on the light.