Star Headlight & Lantern ULB44 The StarBurst Phantom Undercover - Manual (Page 6)

-5-
6. Standard mounting uses the factory
installed visor clips already located on
the vehicle. If you do not have any, use
the Alternate Mounting section page
7 .
7. Locate the two visor clips on the vehicle.
The style may vary from vehicle to vehicle.
Some styles use only one screw each,
while others may have more. Verify that
both visor clips are a minimum of 3” from
the center of the window, and a maximum
of 8” from the center.
8. Loosen (or remove if necessary) both visor
clips enough that one of the forked brackets
can easily slide under each of them.
9. Slide one forked bracket under each visor clip
and tighten the clip such that it securely holds
each bracket in place.
5. Repeat steps 1-3 for the right attaching
bracket .
Bend here if
necessary
10. Once the brackets are
installed securely under
the visor clips or with a
suitable fastener, check
to see that the bottom of
the light is level front-to-
back. If it is not level,
remove the light from the
visor clips and carefully
bend the forked brackets
as necessary. Reinstall
the light and check again
for levelness. Repeat
this process until the light
is level.
Mounting (CONT'D)