Star Headlight & Lantern DL15-30 - Manual (Page 4)

-1-
Preparation
Before beginning the installation:
• Determine where the Traffic Director is to be mounted.
• Check to see that there are no obstructions hindering the visibility of
your traffic director.
• Select a location to mount your controller (purchased separately or
user supplied). The controller must be located in a dry location out of
direct sunlight, free of dirt and dust. Under the vehicle's instrument
panel is usually the best choice.
• Once you have selected these locations, determine the path that
your cable connecting the controller to the Traffic Director will take.
The cable should exit the driver’s side of the rear facing Traffic
Director.
Be sure the cable attached to your Traffic Director is long enough for
proper installation. If it is too short, you will need to order a Traffic
Director with the correct length cable pre-installed. The standard length
for the cables is 15'. Star does not recommend “splicing in”
additional cable when the supplied cable is too short. Traffic
Directors with longer cables are available upon request.