Operation – Star Headlight & Lantern TD93DLXT User Manual
Page 8
-5-
TD77-2 or TD77-2-24Controller
Operation
Important: This product is used to direct traffic. Improper use may
result in vehicular collision, personal injury and/or death. Star
Headlight & Lantern Co., Inc., and its subsidiaries shall not be held
responsible for damages directly or indirectly caused by improper
use of this product. Always carefully consider the effect on traffic
that the selected light pattern will have before engaging the lights.
1. Your new traffic director is a powerful tool that can aid you in traffic control; or if used
improperly, it could direct traffic into a dangerous situation.
USE CAUTION!!!
2. Operation of your Traffic Director
is
straightforward. The controls
include an
On/Off switch, four
Pattern Select buttons, and three
additional "option" buttons.
3. Turn the vehicle's ignition switch to the on or accessories position to supply power to the
controller (if necessary) and press the On/Off switch on the control box. The LED
display should begin to show the "Warn" pattern and the "Warn" label should glow red.
T
D
7
7
-2
Jumper moved to
extra jumper holder
from 1st pair of pins
for Phantom Mode
For standard operation (8-light
traffic directing), the first jumper
remains in the TD77-2 spot
TD77-2 and ULB42-TD-2 Controllers
Arrow stick Control Box Cover Removal
Remove the four recessed Philip head screws (two on each
side of the arrow stick control box). Remove the top cover
by sliding it towards the front of the unit.
Locate the extra jumper
location near the fuses. Move
the jumper from the “Option”
jumper location near the center
of the board over to the extra
jumper section. (See diagram
below).
((Jumper Settings CONT’D)