StorCase Technology DE50 - Manual (Page 17)

10 Installation
StorCase Technology, Inc. PATA DE50 User's Guide - Rev. E00
JMP1
JP1
J1
I/O Connector
Master/Slave
Jumper Option
0849a
Cable Select
Configuration
Jumper Installed
on Pins B & D
(Factory Default)
A B
C D
Typical Master
Drive Configuration
No Jumper
Installed
A B
C D
Typical Slave
Drive Configuration
Jumper Installed
on Pins C & D
A B
C D
Recommended
Configuration
or
Figure 9: Drive Carrier Circuit Board
5. Carefully turn the drive/circuit board assembly upside-down (drive is bottom-
mounted into bracket). Install the mounting bracket/bottom plate assembly and
secure with four (4) M3 screws (provided) as shown in Figure 10.
NOTE: Make sure that the drive circuit board is properly seated in the mounting
bracket slot before tightening screws.