StorCase Technology DE100i-SWC160 - Manual (Page 13)

6 Introduction
StorCase Technology, Inc. DE100i-SWC160 User's Guide - Rev. D01
Figure 5: Receiving Frame Motherboard (Rear View)
• Enable Termination Power Connector (J4): This jumper is installed at the factory
and enables termination power to/from the SCSI bus.
NOTE: Do not remove this jumper!
• Factory-Installed Jumpers (J3): There are two (2) jumpers factory-installed on J3.
One jumper is located on Pins 7 & 8, the other on Pins 9 & 10.
NOTE: Do not remove jumpers! Remove only if attaching the
DX1/200-SWC160/RH Isolator Board (refer to Appendix B for further
information).
J3
J4
P1
DC Power
Connector
(P1)
J3 Jumpers
(Factory-Installed on
Pins 7 & 8 and Pins 9 & 10
Do Not Remove!)
68-Pin I/O
Connector
(J2)
Option Pin
Connector
(W1)
0456d
J4 Jumper
(Factory-Installed
Do Not Remove!)
Buzzer
17 18
19 20
9 10
Factory-Installed Jumpers
(Do Not Remove!)
NOTE: Figure 5 applies to DE100i-SWC160 receiving frames Rev. B00 or higher only! Refer
to Appendix F for further information.