StorCase Technology 14-Bay 4U SCSI Ultra320 - Manual (Page 8)

InfoStation 14-Bay U320 Installation Guide - Rev. A00 StorCase Technology, Inc.
Installation 3
Figure 3: Drive Installation
Installing a Drive into the Drive Carrier
NOTE: Before installing the drive into the carrier, the ID jumpers and spin-up option
jumper on the disk drive must be removed. This is required so that the
InfoStation itself can set the drive SCSI ID and spin-up option.
1. Install the drive(s) into the drive carrier(s). Drive(s) must be side-mounted into the
drive carrier(s) using #6-32 Phillips Pan Hd. screws (Figure 3).
2. After the drive(s) have been installed in to the drive carrier(s), carefully insert the
carrier(s) back into the chassis (refer to section "Inserting a Drive into the Chassis"
for further information).
Drive
Carrier
Ultra160
SCA Drive
(Not Included)
IFS14_8
#6-32 Phillips
Pan Hd. Screw
(2 on each side)
IFS14_9