Taser M26 - Manual (Page 16)

1
ADVANCED TASER® M26 Operating Manual • MMU0008 Rev: B
POLICE/MILITARY K-9 CAUTION
TASER operators and K-9 officers must work closely together to develop SOPs for deploying
the TASER device when a K-9 is present. If a K-9 bites a probe or bites the suspect between
the probes, the K-9 can receive a shock. This could have a negative impact on the future
duty use of the K-9.
M26 MAINTENANCE AND CARE
Each agency should establish a maintenance and handling program.
The M26 is a sensitive electronic device, and should be handled with care. Avoid
dropping an M26. Do not use an M26 with a cracked handle.
The only valid indicator of battery strength is a spark test. Always perform a spark test
after charging batteries.
Alkaline batteries should be replaced when the spark rate is noticeably slower than
normal. Rechargeable batteries should be recharged when the spark rate is noticeably
slower than normal.
Check expiration of TASER cartridges (5-year exp. on the serial number label). Do not
use an expired TASER cartridge.
Occasionally wipe out the TASER cartridge firing bay with dry cloth. Multiple cartridge
firings create carbon build-up (particularly after training courses).
Secure the M26 in a protective holster when not in use.
When an M26 is returned to TASER International for repair, the download data will be
lost. Download the data before returning the unit.
Avoid exposing the M26 to excessive moisture, or water.
See the troubleshooting guide at www.TASER.com for detailed instructions.
DROPPED OR WET M26
Place the safety switch in the down (SAFE) position.
Point in safe direction and safely remove the cartridge.
Remove the batteries.
Dry the M26 thoroughly (at least 24 hours).
Reinstall the batteries.
Place the safety switch in the up (ARMED) position.
If the M26 discharges without pulling the trigger, remove the battery tray and return
the M26 to TASER International immediately.
Spark test for a full five seconds.
If the M26 does not function properly, return it to TASER International.
If the spark test is normal, return the M26 to service.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•