Taser X26 - Manual (Page 11)

TASER® CDPM Operating Manual • MMU0014 Rev: B 11
9.f. Pull the trigger switch. The system will select that number.
A number “5” should then display on the left side of the CID (as seen in
Figure 11).
9.g. Press the Illumination Selector until the desired number
for the fifth activation code digit is displayed on the right
side of the CID.
9.h. Pull the trigger switch. The system will select that number.
9.i. The CID will display the CCDPM battery’s capacity for approximately
six seconds and then will display the letters “CC” to indicate that the
correctional mode has been fully configured (see Figure 12).
Note: Wait until the letters “CC” are displayed before placing the safety switch to the
down (SAFE) position.
Figure 12
Figure 11