Taser X26 User Manual
Page 15
TASER® CDPM Operating Manual •
MMU0014 Rev: B
15
Note: With a CCDPM-configured device, each occurrence of either the CDPM being removed from
the device or the lanyard/wrist strap becoming disconnected from an installed CDPM for two seconds
or more, will require the re-entry of the 5-digit activation code to make the X26 device operational
again.
RE-ENTERING THE ACTIVATION CODE
1. Verify that the TASER cartridge is removed. Failure to remove the TASER cartridge prior to
re-entering the activation code could cause serious injury.
2. Place the safety switch in the up (ARMED) position. The CID displays a blinking “AC” prompting
for the 5-digit activation code.
3. Refer to steps 8-9.h. under “CONFIGURING A TASER X26 DEVICE FOR THE CDPM.”
CHANGING THE ACTIVATION CODE
If it becomes necessary to change a device’s activation code, perform the “CONFIGURING A TASER X26
DEVICE FOR THE CDPM” instructions.