Load the taser cartridge loading, Load the taser cartridge unloading, Aiming and probe placement – Taser X26P User Manual
Page 20
20
Chapter 4
Cartridges & ECD Operation
Loaded
Unloaded
Load the TASER Cartridge
Loading
1
Point the ECD in a safe direction.
2
Ensure that the safety switch is in the down (SAFE) position.
3
Make sure the protective shipping cover is removed from the TASER cartridge.
4
Keeping your hand away from the blast doors, place the cartridge (with the cartridge cover removed) into
the front of the ECD until an audible click is heard.
5
Verify that the cartridge is secure by pulling on the sides of the cartridge.
Load the TASER Cartridge
Unloading
1
Point the ECD in a safe direction.
2
Ensure that the safety switch is in the down (SAFE) position.
3
Keeping your hand away from the blast doors, depress the tabs on the sides of the cartridge and remove.
The 15-, 21-, and 25-foot (4.6- , 6.4-, and 7.6-meter, respectively) TASER cartridges are specifically designed so
there is no “up” or “down” position – enabling you to quickly reload one in a stressful situation without worrying
about putting it in upside down.
Aiming and Probe Placement
Level
Tilted