TFC Group Famoso 555 (7 day) - Manual (Page 5)

6
GB
The heating-cycle setting (CDF value) is
for adapting to the control range.
This is affected by:
– Room size
– Type of heating, e. g. convectors,
storey heating
– Type of assembly
– Temperature control/thermostat
The set value can be altered to achieve
an optimum heating control.
Set the value accordingly with the po-
tentiometer on the rear of the unit.
(Factory setting 4)
Mount device on base and lock.
Recommended positions for Position
Underfloor heating
• Electric
4-5
• Warm water 5-6
3.3 Heating cycle setting/assembly 4. Setting the correct time/weekday
Slide the cover upwards and remove.
Day time switch
e. g. 14.00 h
Turn the dial in the direction of the
arrow until the desired hour is aligned
with the locating arrow.
The precise setting is made with the
minute hand.
Week time switch
e. g. Tuesday 14.00 h
Turn the dial in the direction of the
arrow until the desired week day is in
the area of the locating arrow.
The precise setting is made with the
minute hand.
Only turn in the direction of the arrow
4. Setting the correct time/weekday
GB