Ubiquiti Networks PowerBridgM10 - Manual (Page 14)

Czech Republic
The content in this section is for exclusive use in the Czech
Republic; you are instructed to look for clear channels and
manually set the channel to be used.
Important Steps to Take before First Use
1. Search for channels that are already used in your area. For
these channels, search for the pair channels. NEVER use
these channels for operation of your link.
2. In the airOS Configuration Interface of the
PowerBridgeM10, activate the Frequency Scan List option
and click the Edit button.
3. Select the free channel and save your changes.
4. Follow the same steps (1-3) for your second
PowerBridgeM10 (at the other end of the link).
5. Check the Fresnel zone; this must be free.
6. In the airOS Configuration Interface of the
PowerBridgeM10, use the Speed Test application. Adjust the
direction of the link for optimal performance.
7. Tighten all screws of the antenna.
8. Set TX power in accordance with VO-R/14/12.2006-38.