Ubiquiti Networks UniF AP - Manual (Page 6)

Hardware Installation
The UniFi AP‑PRO can be mounted to the wall or ceiling.
Perform the steps for the appropriate installation:
Wall Mount
1. Position the Mounting Bracket at the desired location on
the wall with the cable feed slot pointed towards the floor.
2. Use a pencil to mark the three holes on the wall. Use a
6 mm (1/4") drill bit to drill the holes.
Top
Optional 25 mm (1 in) Hole for
Ethernet Cable Feed through Wall
3. Follow the instruction for your Ethernet cable feed:
‑ Feeds Through the Wall Cut or drill a circle
approximately 25 mm (1 in) in diameter, just below
the bottom center of the Mounting Bracket (as shown
above). Then feed the CAT5/6 cable through the hole.
‑ Feeds Along the Mounting Surface Remove the
Cable Feed Plug on the side of the UniFi AP‑PRO.
*640-00042-03*
640-00042-03