VDO WR X1 User Manual
Page 144
X1
VDO CYCLECOMPUTING
12
GB
SLO
PL
JP
JP
PL
SLO
GB
www.vdocyclecomputing.com
X1
13
5.2.2 Setting using wheel circumference
>>> P05
To enter the wheel size manually, you must first
measure the wheel roll circumference on your bike.
Measuring wheel roll circumferences:
step 1
Precisely align valve on the front wheel
vertically to the ground.
step 2 Mark this spot on the ground with a line
(e.g. chalk).
step 3
Push the bike forwards one turn of the
wheel until the valve is vertical to the ground
again.
step 4 Also mark this spot on the ground.
step 5 Measure the distance between the two
marks.That is your wheel circumference
(=roll circumference).
step 6 Enter the wheel circumference measured
in this way into your VDO computer.
ATTENTION: If you have selected KMH display,
you must enter the wheel circumference in mm
(If MPH display is selected, enter the wheel
circumference in inches).
How to set the wheel size manually:
Using
go to SETTINGS/
SELECT. Confirm with
M
You are now in setting mode
(pressing
C
for 3 seconds gets
you back to function mode)
Using
go to WHEELSIZE/
SET. Confirm with
M
.
MEASUREMENT/KMH.
Confirm with
M
or
to
change to MPH.
WHEELSIZE/BIKE 1.
(use
to go to setting for
bike 2) Confirm with
M
.
Using
go to
WHEEL-SIZE/MANUAL SET.
Confirm with
M
.
ATTENTION: The factory settings for bike 1 = 2155 mm
and for bike 2 = 2000 mm. If you do not enter any
wheel sizes, the computer works with these fac-
tory settings. The values measured in this way
for speed, distance etc. can differ widely from
the actual values.
BIKE 1 ...SET SIZE/CONTINUE
Now set the wheel roll circum-
ference measured using
.
Confirm the entry with
M
.
BIKE 1/SET OK? Confirm with
M
.
The display confirms: WHEELSIZE/SET DONE.
Automatic return to SETTINGS/SELECT.
How to set the clock:
Using go to SETTINGS/
SELECT. Confirm with
M
.
You are now in setting mode
(pressing
C
for 3 seconds gets
you back to function mode)
Using go to CLOCK/SET.
Confirm with
M
.
CLOCK/24-H-MODE (you can
switch to 12-H mode using .
Confirm with
M
.
CLOCK...SET HOUR/CONTINUE
Set the hours using .
Confirm the hour setting
with
M
.
CLOCK...SET MINUTES/
CONTINUE. Set the minutes
using . Confirm the
minutes setting with
M
.
CLOCK/SET OK? Confirm with
M
.
The display confirms: CLOCK/SET DONE.
Automatic return to SETTINGS/SELECT.
5.3 Setting the clock