VDO WL X1 DW User Manual
Page 159
X1DW
VDO CYCLECOMPUTING
14
GB
SLO
PL
JP
JP
PL
SLO
GB
www.vdocyclecomputing.com
X1DW
15
Attention: The factory settings for bike 1 = 2155
mm and for bike 2 = 2000 mm. If you do not enter
any wheel sizes, the computer works with these
factory settings. The values measured in this
way for speed, distance etc. can differ widely
from the actual values.
BIKE 1 ...SET SIZE/CONTINUE
Now set the wheel roll circum-
ference measured using
.
Confirm the entry with
M
.
BIKE 1/SET OK? Confirm with
M
.
The display confirms: WHEELSIZE/SET DONE.
Automatic return to SETTINGS/SELECT.
How to set the clock:
Using go to SETTINGS/
SELECT. Confirm with
M
.
You are now in setting mode
(pressing
C
for 3 seconds gets
you back to function mode)
Using go to CLOCK/SET.
Confirm with
M
.
CLOCK/24-H-MODE (you can
switch to 12-H mode using .
Confirm with
M
.
CLOCK...SET HOUR/CONTINUE
Set the hours using .
Confirm the hour setting
with
M
.
CLOCK...SET MINUTES/
CONTINUE. Set the minutes
using . Confirm the
minutes setting with
M
.
CLOCK/SET OK? Confirm with
M
.
The display confirms: CLOCK/SET DONE.
Automatic return to SETTINGS/SELECT.
5.3 Setting the clock
You can program the values on the distance coun-
ter at any time (e.g. at the end of a season).
Using go to SETTINGS/
SELECT. Confirm with
M
.
You are now in setting mode
(pressing
C
for 3 seconds gets
you back to function mode).
Using
go to ODOMETER/
SET. Confirm with
M
.
5.4 Setting the total kilometres
ODOMETER/ODO BIKE 1
(use to go to setting for
BIKE 2). Confirm with
M
.
ODO BIKE 1 ...SET DISTANCE/
CONTINUE.
You can set the flashing digits
using . To access the next
digit, confirm with
M
.
Repeat the steps until the last
digit on the right is flashing.
Confirm with
M
.
ODO BIKE 1/SET OK? Confirm with
M
.
The display confirms ODO BIKE 1/SET DONE.
Automatic return to SETTINGS/SELECT.
5.5 Switch from bike 1 to bike 2
>>> P03
The selected Bike 1 or 2 is shown
on the display bottom left (
).
Note: The transmitter on bike 2 must have been
set to bike 2 before using it the first time.
>>> P03
Your VDO computer can be used on 2 bikes.
If you switch from bike 1 to bike 2, the computer
recognises the transmitter from bike 2. The
computer then automatically switches to bike 2.
All data are now saved for bike 2. When you use
the computer again on bike 1, transmitter 1 is
recognised. The computer switches to bike 1.
The data are now saved for bike 1.