VDO WL X2 DW User Manual
Page 174
X2DW
VDO CYCLECOMPUTING
16
GB
SLO
PL
JP
JP
PL
SLO
GB
www.vdocyclecomputing.com
X2DW
17
You can set the flashing digits
using .
To access the next digit, con-
firm with
M
. Repeat the steps
until the last digit on the right
is flashing. Confirm with
M
.
ODO BIKE 1/SET OK? Confirm with
M
.
The display confirms ODO BIKE 1/SET DONE.
Automatic return to SETTINGS/SELECT.
5.5 Switch from bike 1 to bike 2
>>> P03
The selected Bike 1 or 2 is shown
on the display bottom left (
).
Note: The transmitter on bike 2 must have been
set to bike 2 before using it the first time.
>>> P03
Your VDO computer can be used on 2 bikes.
If you switch from bike 1 to bike 2, the computer
recognises the transmitter from bike 2. The
computer then automatically switches to bike 2.
All data are now saved for bike 2. When you use
the computer again on bike 1, transmitter 1 is
recognised. The computer switches to bike 1.
The data are now saved for bike 1.
5.6 Service interval display
Press any button. The text BIKE SERVICE
disappears again. After another 50 km the also
disappears. You can also switch off the flashing
-symbol. To do so, enter the service interval again.
How to set the service interval:
Using go to SETTINGS/
SELECT. Confirm with
M
.
You are now in setting mode
(pressing
C
for 3 seconds gets
you back to function mode).
The VDO service interval display reminds you to
have your bike checked in the workshop.
You can switch the service interval ON or OFF.
You can set separate service intervals for 2 bikes
When the set service interval distance has been
reached:
B
The -symbol flashes on the display.
B
The information line displays
BIKE SERVICE/BIKE 1
You should now either carry out the
recommended bike check yourself or have
the bike checked by your dealer.
Using go to BIKE SERVICE/
SET. Confirm with
M
.
BIKE SERVICE/ON (switch to OFF
using ). Confirm with
M
.
BIKE SERVICE/BIKE 1
(use to switch to bike 2)
Confirm with
M
.
BIKE 1 ...SET DISTANCE/
CONTINUE. You can set the flash-
ing digits using To access
the next digit, confirm with
M
.
Repeat the steps until the last digit on the right
is flashing. Confirm with
M
.
BIKE 1/SET OK? Confirm with
M
.
The display confirms: BIKE SERVICE/SET DONE.
Automatic return to SETTINGS/SELECT.
5.7 The navigator
With the VDO navigator you can complete trips
according to Roadbooks. Roadbooks = tour
descriptions with km information for certain
points of orientation. The VDO navigator is an
independent km counter and can count forwards
or backwards. The km status can be set at
any desired point. You can therefore start in
the middle of a trip or make a km correction
if you have taken a wrong turn.
Setting the navigator:
Using go to NAVIGATOR/
SELECT. Confirm with
M
.
NAVIGATOR/SET. Confirm with
M
.
You are now in setting mode
(pressing
C
for 3 seconds gets
you back to function mode).