Installation, Continued, Installing logs – Desa CF26NT User Manual

Page 15

Advertising
background image

111410-01C

For more information, visit www.desatech.com

For more information, visit www.desatech.com

15

15

Figure 26 - Checking Gas Joints for Propane/LP Units (Shown
with Optional Mantel)

Equipment Shutoff Valve

Propane/LP

Supply Tank

INSTALLATION

Continued

Pressure Testing Fireplace Gas Connections

1.

Open equipment shutoff valve (see Figure 24, page 14).

2.

Open main gas valve located on or near gas meter for natural
gas or open propane/LP supply tank valve.

3.

Make sure control knob of fireplace is in the OFF position.

4.

Check all joints from equipment shutoff valve to thermostat
gas valve (see Figure 23, page 14). Apply noncorrosive leak
detection fluid to gas joints. Bubbles forming show a leak.

5.

Correct all leaks at once.

6.

Light fireplace (see Operating Fireplace, pages 16 and 17).
Check all other internal joints for leaks.

7.

Turn off fireplace (see To Turn Off Gas to Appliance, page 16).

8.

Replace front panel.

WARNING: Failure to position the parts in accor-

dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.

INSTALLING LOGS

It is very important to install the logs exactly as instructed. Do not
modify logs. Only use logs supplied with heater.

Place one-piece log set on grate to fit as illustrated in Figure 27.
Make sure back section of log set is seated into “U”-shaped cutout
in center of chassis (see Figure 27).

IMPORTANT:

Make sure log

does not cover any burner ports (see Figure 28).

CAUTION: After installation and periodically there-

after, check to ensure that no flame comes in contact
with any log. With the heater set to HI, check to see if
flames contact any log. If so, reposition logs accord-
ing to the log installation instructions in this manual.
Flames contacting logs will create soot.

LO

PILO

T

OFF

HI

One Piece Log Set

"U"-shaped
Cutout in
Chassis

Chassis

Figure 27 - Installing One-Piece Log Set

Figure 28 - Installing One-Piece Log set (Top View)

One Piece Log Set

Burner Ports

Burner

INSTALLATION

Checking Gas Connections (Cont.)

Installing Logs

Advertising