Velodyne vPulse - Manual (Page 4)

Selecting the right ear tip
Choosing the right ear tips will give you the best possible sound isolation and bass response.
Listen to a song that you know has deep bass. Change the ear tips until you find the smallest size that gives
you the most bass extension.
Be sure to position the ear tips to fit your ears snugly.
Always turn down the volume on your device before inserting the ear tips into your ears. Once the ear tips are
inserted, gradually increase the volume to a moderate sound level.
To change an ear tip
Gently pull on the outer baffle of the attached tip to remove it. To attach a new tip, align the tube with the
driver grill at its end with the center tube of the ear tip and press on the tip until the driver tube is fully
covered.
Wearing vPulse
Make sure ear tips are clean before inserting into your ears.
Wear the ear piece marked “R” in your right ear and the one marked “L” in your left ear. The left ear piece is
the one with the control module on its cable.
Using the cord slider
Move the slider up and down to change the split position of the cord. Store vPulse with the slider all the way
up to help reduce cord tangles.
Cleaning
Ear tips should be cleaned regularly for sanitary reasons and to prolong the life of your ear tips.
With a lightly dampened cloth, paper towel or disinfectant wipe, thoroughly clean the ear tips.
Use a dry cloth to pat away any remaining moisture.
Do not get the speakers or electronics inside of your
vPulse wet. Liquids and heavy moisture can cause
damage to the electronics inside your vPulse. Such
accidental damages are not covered under warranty.
Page 2 of 5
vPulse user’s guide