Vermona qMI - quad MIDI Interface - Manual (Page 12)

Circuit board jumpers (CV / GATE)
Two plug-in-jumpers to the side of the module's circuit board can be
used to send key-CV- and gate voltages of CV/Gate channel 1 to the
system bus. With the plug-in-jumper set next to the CV/GATE label, the
connection to the system bus is active. This way, front panel cable
connections for this function are no longer necessary with the receiving
modules being mounted on the same bus circuit board (resp. a CV/Gate
connection has been made across several bus circuit boards). With the
jumper set next to the OFF label, the connection to the system bus is
inactive.
Picture 4: Jumper settings for CV1 and Gate
NOTE A distribution of key-CV- and gate-signals across the
system bus is useful where multiple oscillators and
envelopes are present. Here, the internal signal distri-
bution replaces the need for multiples. Unfortunately,
not all oscillators support system bus distribution. If
this is the case, key-CV has to be patched the usual
way.
CV1 / GATE1
on systembus CV1 / GATE1 not on systembus
Owner's Manual - VERMONA*modular qMI - quad MIDI Interface
- 12 -