Voodoo Lab Pedal Power Digital - Manual (Page 6)

- 4 -
1, 2) 9V and 12V high-current output pairs. Each pair is an isolated output
section providing up to 400mA.
Note: The 9V and 12V outputs within a pair are not isolated from each other
(their negative terminals are common). It is preferred to use only one from each
pair. If using both, combined output should not exceed 400mA.
Important: Do NOT operate two high-current digital effects from the same
isolated section by using both 9V and 12V jacks of the pair.
3, 4) 9V high-current outputs. Use for all devices which require 400mA or less.
All 9V outputs can also power ordinary low-current battery operated pedals.
DC Power Cables
The Pedal Power end of each supplied DC power cable has a black barrel
connector. The other end has either another identical black barrel connector
(center negative) or a 5.5x2.5mm red barrel (center positive). Use the standard
right-angle black barrel connector cables with most common 9V battery operated
pedals.
Before powering your pedal with the standard black barrel connector, you must
verify that the pedal requires “center negative” polarity to prevent damage.
Cables are available from Voodoo Lab to properly power “center positive” pedals.
Line 6
Line 6 M5 and Tone Core pedals, plus Pocket POD can be powered from any
available 9V output using a standard black 5.5x2.1mm barrel cable.
You can power Line 6 modeling pedals, like DL4 or MM4, using the 12V outputs
with a red 5.5x2.5mm barrel cable. This does not match the rating of the supplied
Line 6 adapter, but does correctly power these pedals. Note that PODxt & HD,
M9, M13 and the JM4 Looper cannot be powered by Pedal Power Digital.