Voodoo Lab MX-28M - Manual (Page 2)

Merge
In Merge mode, the MX-28M will merge data from INPUT 1 with the data from INPUT
2.
Transpose
Select TRANSPOSE (the middle position) with the Function Select Switch. When the
PGM button is depressed briefly (see RESET), the Red LED above the word
“TRANSPOSE” will blink rapidly and the Green LED above the word “FROM” will
illuminate.
Press the note on your keyboard that defines the key you wish to transpose from. The
Green LED above the word “TO” will illuminate. Press the note on your keyboard that
defines the key you wish to transpose to.
Example:
If you are playing in the key of C and you wish to transpose to the key of F#, you would
perform the following sequence.
1. Select TRANSPOSE.
2. Press PGM button.
3. Play C on your keyboard connected to INPUT 1.
4. Play F# on your keyboard.
Transposed MIDI data is send to each selected output.
Map
In MAP mode, four completely independent zones can be defined. These zones can be
splits, layers or combinations of both. Each zone is then output on its own MIDI channel
to each selected output. The first defined zone is transmitted on the same MIDI channel
number as the input channel number, and each of up to three additional zones are output
on the next higher MIDI channel number.
Example:
If four zones are defined and the input channel is MIDI channel 4, the zones will be
output as follows.
zone 1 on channel 4
zone 2 on channel 5
zone 3 on channel 6
zone 4 on channel 7
Select MAP (the uppermost position) with the Function Select Switch. The default MAP
sends the entire keyboard range to all four zones (i.e. four channels are layered on each
note) for instant LAYERING.
To define SPLITS and LAYERS in any combination, press the PGM button. When the
PGM button is pressed, the Red LED above the word “RANGE” will blink to indicate