Vortech 1991-1995 5.2L/5.9L Dakota/Ram User Manual

Page 12

Advertising
background image

A. An additional fuel pump is supplied to insure

that sufficient fuel is available to the engine.
This pump is mounted on the left side inner
fenderwell.

B. Open, then close the fuel filler cap to vent any

residual pressure. Disconnect the stock fuel
supply hose where it enters the fuel rail.

C. Following the graphic on the next page,

inserthose assembly "A" into the factory feed
lin until it snaps into place.

D. Drill a .25" hole in the dimple located in the to

center of the left inner fenderwell.

E. Attach the Vortech fuel pump to the fenderwell

with the outlet pointing forward using the
supplied adel clamp and #10 hardware. See
photo at right.

F. Attach the supplied length of red wire from the

(+) terminal on the pump through the firewall to
the fusebox. Use the power from the heater
blower fuse.

G. Connect the ground wire from the (-) terminal

on the pump to the existing ground bolt in the
fender apron.

H. Assemble the brass fittings as shown an

connect hose assembly "B" to the fuel rail.

6

8B. AUXILIARY FUEL PUMP (1994-96 Models Only)

WARNING: Take great care to
minimize fuel spillage and always
have a second person stand by with a
fire extinguisher as a precaution.

NOTE: On ABS equipped vehicles,
the pump mounting position may vary
slightly. Remove the windshield
washer reservoir to gain access to
mounting area.

Advertising