Vortech 1991-1995 5.2L/5.9L Dakota/Ram User Manual
Page 9
5. SUPERCHARGER MOUNTING
A. Attach the oil drain hose to the
drain fitting on the bottom of the
supercharger and secure with the
clamp provided. Make sure to
position the clamp housing to the
side so that it does not interfere
with the mounting plate.
B. Set the supercharger in place on
the plate and secure with the five
3/8-16 x 1" bolts and washers.
C. Attach the plastic idler pulley to
the inner most threaded boss on
the supercharger using the large
washer as a spacer in between
as shown.
3
NOTE: This drive belt is
custom made for Vortech
and is obtainable as a spare;
however, should an
emergency arise, a Gates
P/N K060113 six rib belt may
be used temporarily.
A. The new longer accessory drive
belt is routed the same as the
original belt except for
accommodation of the
supercharger an idler pulley.
B. Route the belt around the outside
of the supercharger drive pulley
then around the inside of the idler
as shown.
C. The stock tensioner is used as
originally intended in its relocated
position.
6. SUPERCHARGER/ACCESSORY DRIVE BELT