Vortech 1999-2001 Ford 5.4L/6.8L Super Duty/SUV - Manual (Page 5)

P/N: 4FT020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
02AUG04 v2.1(99-03SuperDuty(4FT v2.1))
Before beginning this installation, please read through this entire instruction booklet and the Street
Supercharger System Owner's Manual which includes the Automotive Limited Warranties Program
and the Warranty Registration form.
Vortech supercharger systems are performance improving devices. In most cases, increases in torque of
30-35% and horsepower of 35-45% can be expected with the boost levels specified by Vortech Engineering.
This product is intended for use on healthy, well maintained engines. Installation on a worn-out or damaged
engine is not recommended and may result in failure of the engine as well as the supercharger. Vortech
Engineering is not responsible for engine damage.
Installation on new vehicles will not harm or adversely affect the break-in period so long as factory break-in
procedures are followed.
For best performance and continued durability, please take note of the following key points:
1. Use only premium grade fuel 91 octane or higher (R+M/2).
2. The engine must have stock compression ratio.
3. If the engine has been modified in any way, check with Vortech prior to using this product.
4. Always listen for any sign of detonation (pinging) and discontinue hard use (no boost) until problem is
resolved.
5. Perform an oil and filter change upon completion of this installation and prior to test driving your vehicle.
Thereafter, always use a high grade SF rated engine oil or a high quality synthetic, and change the oil
and filter at least every 3,000 miles. Never attempt to extend the oil change interval beyond 3,000
miles, regardless of oil manufacturer's claims as potential damage to the supercharger may
result.
6. Before beginning installation, replace all spark plugs that are older than 2 years or 30,000 miles with
original heat range plugs as specified by the manufacturer and reset timing to factory specifications
(follow the procedures indicated within the factory repair manual and/or as indicated on the factory
underhood emissions tag). Do not use platinum spark plugs unless they are original equipment.
Change spark plugs at least every 30,000 miles.
TOOL & SUPPLY REQUIREMENTS:
• Metric and standard - socket set, wrench set
• Ratchet - 1/2” drive
• Extension
• 1/2" drive breaker bar
• Ford springlock tool 3/8" & 1/2”
• Pliers
• Drill motor
• Ø1/16" and #30, Ø9/32”, and Ø11/16” drill bits
• Test light
• Rubber mallet or dead blow hammer
• Harmonic balancer puller and installer
• Wire cutters and crimping tool
• Standard hex key set (Allen wrenches)
• Alcohol (denatured or rubbing)
• Silicone sealer/RTV
If your vehicle has in excess of 30,000 miles since its last spark plug change, then you will also need:
• Spark Plug Socket
• NEW Spark Plugs
1999-2003
FORD SUPER DUTY
Installation Instructions
1999-2001 50 State Smog Legal, as per CARB EO #D-213-17
Congratulations on selecting the best performing and best backed automotive
supercharger available today... the VORTECH ® V-2 ® Supercharger!
v