Vortech H3 I-5 Hummer - 2006-2008 User Manual
Page 13
P/N: 4GN020-010
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
20OCT08 v2.0(4GNv2.0)
5
Fig. 4-a
Fig. 4-b
Fig. 4-c
4. OIL FEED INSTALLATION (ENGINE OIL-FED kITS ONLY. APPLICATIONS WITh
V-3 SUPERChARGERS SkIP AhEAD TO STEP 5)
A. Locate the plug just above the oil filter on the
passenger’s side of the engine. Using a 5/16"
Allen wrench, remove the plug and discard.
(See Fig. 4-a.)
B. Install the M16 to –4 fitting and sealing wash-
er provided where the plug was previously
removed and tighten using a 7/8" wrench.
(See Fig. 4-b.)
C. Attach the 90° end of the supplied –4 stain-
less steel oil line to the previously installed
M16 to –4 fitting. (See Fig. 4-c.)
D. Route the line away from hot, sharp or mov-
ing parts and toward the top of the engine
where it will be attached to the supercharger
oil feed.
E.
Cover the open of the line to prevent contam-
ination until the connection to the supercharg-
er is made in a later step