Vortech Universal Big Block Carbureted System - Manual (Page 15)

P/N: 4GA020-030
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
08DEC08 V3.0(BBC LowMount(4GA..030 V3.0))
7
A. Install the correct length V-belts onto the
water pump, power steering and crank pul-
leys.
B. Tighten all bracket hardware that was
“snugged” earlier and adjust/tighten the
V-belts making sure all belts are routed cor-
rectly. Make sure all hoses and wiring are
routed correctly and secured, that all coolant
modifications are complete and hose clamps
are properly tightened.
6. ACCESSORY DRIvE BElTS (TWIN PlATE v-7 ONlY, v-4 RACE SKIP TO
SECTION 8)
NOTE: Belts are to be sized per each application and
purchased separately and are not included in this
base kit.