Vortech Universal Big Block Carbureted System User Manual
Page 22
P/N: 4GA020-030
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
08DEC08 V3.0(BBC LowMount(4GA..030 V3.0))
14
12. DISCHARGE DUCTING/CARBURETOR ENClOSURE
A. Install optional Vortech carburetor enclosure
(if not already completed) assembly #8M205-
012. Instructions are included with the enclo-
sure assembly. The enclosure lid is to be
attached to the base with the inlet facing the
passenger’s side of the vehicle.
B. Attach the short 90° aluminum elbow with
flange to the enclosure inlet using the sup-
plied gasket, 5/16-18 x 1 bolts and washers.
C. Install the long 3-1/2" aluminum elbow in
between the supercharger discharge and the
90° flange elbow using the 3.5” sleeve, #56
clamps, #48 clamp and reducer.
NOTE:
Depending on the vehicle application
and hood configuration, minor bottom
side hood modifications may be required.