Vortech 1992-1996 5.7L LT1 Corvette - Manual (Page 15)

5
6. FUEL MANAGEMENT UNIT INSTALLATION, cont'd.
TO FMU
OUTLET
TO FMU
INLET
•
•
NOTE: Make sure you have routed
all fuel lines away from all moving
parts, sharp edges, exhaust pipes
and manifold. Secure the fuel lines
with the tie wraps.
FUEL
FEED
LINE
FUEL
TANK
STANDARD
PUMP
ADDITIONAL
FUEL PUMP
FUEL
RETURN
LINE
FUEL
MANAGEMENT
UNIT (FMU)
ENGINE
TO MANIFOLD PRESSURE
C. Using a spring-lock fitting disconnect tool,
disconnect the return line (the line closest
to the front of the car) from the fuel rail (at
the top rear of the intake manifold).
D. Install the supplied 45" fuel line by
connecting the female spring-lock end
onto the fuel rail. Run the line parallel to
the feed line and then downward behind
the wheel well to the FMU. The flare end
will be connected to the 90
°
inlet fitting on
the FMU.
E. Fit the 28" male fuel line into the braided
tank return line. Route the braided tank
return line assembly forward to form a
smooth radius pointing downward. Use
tie wraps to hold the line in position.
Route the flared end of the line downward
behind the wheel well with the other FMU
line to the FMU. Connect the line to the
center fitting.