Vortech 2003-2006 G35 - Manual (Page 24)

P/N: 4NZ020-010
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
04JUN08 v6.0 Nissan 350Z(4NZv6.0)
6
A. (Non oil fed applications skip this step) Install the
supplied Ø1/2" fabric-braid oil drain line onto the
supercharger fitting and tighten the supplied hose
clamp.
B. (Non oil fed applications skip this step) Install the
supplied 1/8"NPT x -4 straight fitting into the super-
charger oil feed nozzle using motor oil on the
threads. Attach the supplied oil feed hose to the fit-
ting and tighten.
NOTE: Oil in the supercharger is gravity drained to the oil
pan. Trim the supplied oil drain hose as necessary
so that it is continuously sloping down towards the
oil pan. Avoid dips, kinks, etc.
NOTE: Use clean oil on the pipe (tapered) threads. Teflon
tape or sealant is not recommended as it may loos-
en and cause blockage of the small oil feed orifice
resulting in supercharger failure.
NOTE: 2003-2005 standard output engine only. (For 2005
and later high-output 300hp engines, skip to Section
6.)
C. Install the six mounting screws and washers through
the mounting plate in the positions shown. (See Fig.
5-a.)
D. Install the supercharger onto the mounting plate and
install and tighten the four 3/8" x 1" screws and
washers.
E. Install the supplied gilmer (toothed) belt around the
pulleys on the mounting plate assembly. (See Fig.
5-b.)
F. Install the four supplied spacers onto their respective
screws. (See Fig. 5-b.) A small dab of sealant
between the spacer and the mounting plate may
help retain them during the following steps.
G. Position the supercharger mounting plate assembly
in front of the engine and start all of the mounting
screws.
H. Make sure that the coolant hose is routed in the
groove on the back of the supercharger mounting
plate.
I. (Non oil fed Applications skip this step) Verify that
the oil drain hose is routed as smoothly as possible
and connect it to the fitting on the oil pan. Tighten a
hose clamp on this connection. Secure the oil drain
hose and the A/C line away from the A/C pulley with
zip-ties. Trim drain hose length if necessary.
J. (Non oil fed Applications skip this step) Route the oil
feed hose outside the driver’s side frame rail and
then to the fitting installed near the oil filter and tight-
en. Use the supplied zip-ties to secure.
K. Tighten all of the mounting plate screws.
L. Install the air filter onto the supercharger inlet and
tighten the clamp.
5. SUPERCHARGER MOUNTING PLATE INSTALLATION..(2003-2006 Standard
Output Engines Only.) ( For 2005 and Later “Rev-Up” Engines, Skip to
Section 6.)
Fig. 5-a
Fig. 5-b
M6 x 20mm
M12 x 40mm
M12 x 110mm
M6 x 25mm
M6 x 70mm
Ø.5" x .254" SPACER
Ø1.0" x .602" SPACER
Ø.5" x 1.175"
SPACERS
Fig. 5-c