Vortech 1994-1998 4.6L Mustang T-Rex - Manual

A. Remove spare tire, etc. from trunk.
B. Trim "Cut-Out" from the template provided in the kit and
place over spare tire hold-down. Centerpunch and drill the
four 3/16" holes in the trunk floor.
C. Jack up the rear of the car and support with jack stands.
D. Mount the T-Rex fuel pump to the underside of the tire well
with the rubber mounts, adel clamps and fasteners provided.
Refer to the graphic on the following page.
E. Remove the female hose end connected to the fuel filter
inlet.
F. Insert the T-Rex inlet hose assembly into the female supply
hose fitting by gently pushing the fittings together and
making sure they are locked.
G. Fasten the extended feed line clear of the filter by looping
the two 11" cable ties through the front slot on the fuel filter
mount, being careful not to kink the line.
H. Plug the female connector located on the T-Rex discharge
line onto the fuel filter inlet making sure the hose assembly
clears all exhaust tubing and sharp objects.
I. Position the reflective sleeve on the pump discharge line
so that it receives maximum protection from the tailpipe.
J. Mark and drill a 1/8" hole and mount the relay inside the
trunk in position as shown in the template. Use the sheet
metal screw provided.
K. From relay terminal #85, tap the yellow wire into the stock
fuel pump harness in the trunk near the right tail light. Tap
into the purple wire with the supplied scotch lock. (On some
model years, wire may be brownish-green.)
L. Connect the short red wire on relay terminal #8 to the (+)
terminal on the fuel pump.
M. Connect the longer black wire from the (-) terminal on the
fuel pump to a clean ground.
N. Connect the short black wire to a clean ground from relay
terminal #86 (relay screw mount works well).
O. Route the remaining long red wire from relay terminal #30
up to the fuse panel located under the dash. Using a
solderless connector, connect the supplied fuse holder and
fuse to the end of the wire. Crimp the fuse wire to the
supplied female slide and fuse tap. Attach fuse tap and
wire to fuse #17.
1
T-REX ® FUEL PUMP INSTALLATION (P/N 8F202-265)
1994-1998 FORD MUSTANG T-REX FUEL PUMP INSTALLATION
NOTE: Use extreme caution when routing
fuel lines. Make sure fuel lines are located
away from hot exhaust pipes and sharp
edges on vehicle underbody.