Volant Wrangler Periscoop Snorkel TJ User Manual

Installation intructions

Advertising
background image

INSTALLATION INTRUCTIONS

PART NO.

37640

8759 Lion Street
Rancho Cucamonga, CA 91730
(909) 476-7225 TECH SUPPORT
(909) 476-1491 FAX
www.volantperformance.com

1. Cut out the template along the dotted
line with a pair of scissors.

2. Align template along the side base of
the jeeps passenger fender. Tape the
template to the fender.

3. Once the template is lined up and taped
to the fender, drill two 1/8" pilot holes as
noted on the template.

4. Remove the template from the fender.
Drill a 3" hole with a hole saw on the top
1/8” pilot hole and a 3/8” hole with a drill
bit on the lower pilot hole.

5. Remove the two top counter sink bolts
from the front windshield bracket with a
torx key #40 Note: In order to loosen the
bolts, tap them lightly with a hammer to
loosen the Loc tite.

READ INSTRUCTIONS THOROUGHLY
BEFORE DISASSEMBLING. DO NOT
SKIP ANY STEPS. ANY QUESTIONS ON
A VOLANT KIT MAY BE REFERRED TO
OUR TECH SUPPORT LINE AT (909)
476-7225 OR VISIT OUR WEBSITE AT
WWW.VOLANTPERFORMANCE.COM

TOOLS NEEDED FOR INSTALL:

1. FLATHEAD SCREWDRIVER
2. 10 MM SOCKET
3. RATCHET
4. 10/32 SOCKET

APPLICATION GUIDE PART NO. 37640

MY

MAKE MODEL

ENG.

1997-2006 JEEP WRANGLER 4.0L

RECOMMENDED SERVICE PART NUMBERS

VOLANT

REPLACEMENT

FILTER

5113

AIR

FILTER

CLEANER

KIT

5100

6. Place the 3" X 3" sleeve on the small
opening of the Volant down pipe and the 3
¼” X 2" sleeve on the other end of the
short snorkel..

Advertising