WatchGuard QMS 1200 - Manual (Page 4)

• Install the device in a secure location, preferably in a locked equipment rack or secure
server room.
• Connect the power cord to the power socket on the back panel of the device.
• To access the Web UI Setup Wizard, connect to the WatchGuard QMS using one of
these methods:
o Connect your computer to the same network as the WatchGuard QMS through a
network switch. Connect the WatchGuard QMS to the network switch using the
first onboard Ethernet connector (NIC 1) at the left side of the back panel.
o Connect your computer directly to the WatchGuard QMS using a cross-over
Ethernet cable connected to the first onboard Ethernet connector (NIC 1) at the
left side of the back panel.
• The default IP address on the WatchGuard QMS is 10.0.0.1/24.
• Configure your computer to use the IP address 10.0.0.2 with a netmask of
255.255.255.0 to connect to the WatchGuard QMS.
• Power on your device. Wait at least five minutes for the system to initialize before you
try to connect to the WatchGuard QMS with a web browser.
NOTE: Ping is enabled on the configured network interface. You can ping the default address 10.0.0.1 to
check connectivity before you connect with a web browser.
• Open a web browser and type https://10.0.0.1 to start the Web UI Setup Wizard.
NOTE: Because the QMS device uses a self-signed certificate, you may see a certificate warning in your
browser. It is safe to ignore the warning (Internet Explorer) or to add a certificate exception (Mozilla Firefox).
• On the Login page, type the default user ID (admin) and the default password (admin).
• Follow the instructions on the screen and complete the Wizard.
NOTE: Make sure you enter your feature key during the Wizard.
• Log in to the WatchGuard QMS Web UI with the user name admin and the new
password you set in the Wizard.
Connect your WatchGuard® QMS
3
Connection and Installation
Switch
NIC 1
Ethernet cable
Ethernet
cable
[Optional monitor
and keyboard
for console access]