Wisdom Audio Sage Series C38 - Manual (Page 14)

14
intended area behind the wall before you begin marking and cut-
ting!
2. Trace the outer perimeter of the cutout guide with a pencil or a
utility knife.
3. Remove the traced section of sheet rock using a keyhole saw, and
clear debris from the edge of the hole.
4. Push any insulation to the side.
5. Disassemble bezel/Uni-Grip™ and place the supplied Allen head
screws to the side. Place the bezel in the wall cutout and insert
the Uni-Grip clamping bar through the opening at an angle, work-
ing on one side first. Reinstall the Allen head screws with the
supplied 3/32” drill bit, securing both pieces to each other (sand-
wiching the wall between them), but do not tighten yet. Repeat on
the other side.
6. Using a level, adjust assembly in wall cutout to ensure that the
assembly is plumb. Tighten the Allen screws. Do not over torque
or strip these screws. The large clamping area of the Uni-Grip
system does not require unusually high torque on the screws to be
secure.
7. Paint the bezel and grill as necessary, being careful not to plug
up the holes in the grille. Note that the speaker modules are not
mounted in the bezel and grille assembly at this time. They can
be mounted later, after all the paint is dry.
8. Using assistance to hold the speaker modules away from the wall,
connect both high and low pass speaker cables to the two con-
nectors at the end of the back box, paying attention to assign the
correct band-pass and polarity to their respective speaker connec-
tors.
9. Insert the speaker/back box assembly into the Uni-Grip frame and
attach using the supplied Allen head screws and 3/32” drill bit.
Do not over torque or strip these screws.