Wyred 4 Sound STmkII Series - Manual (Page 9)

pg. 7
flush with the back of the unit. The “Out Position” will be defined as when the
switch is in the extended position and not flush with the back of the unit
DC Trigger
Near the left side of the rear panel is a 12V DC trigger in and out. The trigger
“IN” will turn the unit on from standby once it is actively fed 12V DC. This feature is
very convenient because it will allow the ST
mkII
to automatically power on and off
whenever the source is turned on or off. For example products such as our mPRE,
mINT, DAC-2, STP-SE and STI all have 12V DC trigger outputs that you can use for
this. You will also find many processors and AV receivers that have a compatible
trigger feature. The trigger “OUT” will be active whenever the amp is powered on
and allows it to trigger on other components such as another ST
mkII
. There will be a
slight delay in the trigger out to help smooth any possible power-up surges.
Back Panel Diagram
1. On/Off power switch
2. Fuse holder and AC power input
3. 120V/230V mains voltage selector switch
4. Right channel speaker output
5. Right channel XLR input
6. Left channel XLR input
7. Left channel speaker output
8. 12V DC Trigger
9. Right channel RCA input
10. Right channel RCA/XLR input select switch
11. Left channel RCA input
12. Left channel RCA/XLR input select switch