XAIRCRAFT MINIX - Manual (Page 11)

9
©2013 XAircraft All Rights Reserved.
Flight Controller installation notice:
1. Should be installed in cg position on copter.
2. Should pay attention to install direction, the triangle points to the head of copter.
GPS module installation notice:
1. Horizontal install, higher than other electronic equipment.
2. Should pay attention to install direction, the triangle points to the head of copter.
3. Close to Flight Controller.
4. Far away from motor and other electric equipment.
Connection to Receiver
Connect to Receiver
Power Supply
MiniX use JST-3Pin signal (Futaba) power wire, one end connected to lipo battery and the other
connected to BAT port on FC.
MiniX Connect with Computer
1. MiniX power on. (USB of computer does not supply power to MiniX）
2. After Flight Controller connected with computer, your windows shows a disk named“MiniX”
in “My computer“
*Battery Range:2S~6S