MagnaFlow BMW 325IS Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

Step 1:(Carefully read all instructions before
installation) Begin removing the OEM exhaust
system by first unbolting both clamps attaching the
muffler assembly to the catalytic converter outlet
pipes. Remove the mounting hardware securing the
muffler. Working front to rear remove the system. Be
sure to retain and not to damage all mounting
hardware as it will be needed to mount your new
MAGNAFLOW exhaust system.
Step 2: Install your new system by first loosely
bolting the driver and passenger side inlet pipe
assembies to the catalytic converter outlet pipes. Slip
the inlet pipes of the muffler assembly over the outlet
ends of the two inlet pipe assemblies. Loosely
secure using the supplied clamps.
Step 3: With all components mounted loosely, adjust
the system for overall aesthetics and clearance of
frame & bodywork. (MAGNAFLOW recommends at
least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.)
Step 4: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be VERY tight
to properly align the pipes and prevent leaks
(Approximately 40ft-lbs). U-bolt clamps should be
tightened to approximately 30-35ft-lbs. Inspect all
fasteners after 25-50 miles of operation and retighten
if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
16534
1992 - 1995 BMW 325 2.5L
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
Nov 16, 2010
Rev: 000
Muffler Assembly
Inlet Pipe Assy. D/S
Inlet Pipe Assy. P/S
2X 2.25" Clamps