Denon AVR-2106 - Manual (Page 28)

ENGLISH
25
ENGLISH
Basic Operation Basic Operation
• When making parameter settings, the display will return to the
regular condition several seconds after the last button was
pressed and the setting will be completed.
2 Press and hold in the SURROUND PARAMETER
button to select the parameter you want to set.
3 Display the parameter you want to adjust, then
turn the
SELECT knob to set it.
The parameters which can be set differ for the different
surround modes are displayed. (Refer to “Surround modes
and parameters” (
page 53).)
When turned counterclockwise:
DIRECT STEREO
MONO MOVIE DTS NEO:6 5CH/7CH STEREO
MATRIX VIRTUAL SURROUND
DOLBY PRO LOGIC II x
ROCK ARENA JAZZ CLUB VIDEO GAME
To select the surround mode while adjusting the surround
parameters, tone defeat or tone control, press the
SURROUND MODE button, then operate the selector.
SELECT SURROUND PARAMETER
TONE DEFEAT
SURROUND MODE
TONE CONTROL
SURROUND
PARAMETER
CH SELECT/ENTER
SURROUND
MODE
CURSOR
2 Surround parameters r
ROOM SIZE:
This sets the size of the sound field.
There are five settings: “small”, “med.s” (medium-small),
“medium”, “med.l” (medium-large) and “large”. “small”
recreates a small sound field, “large” a large sound field.
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15. Lower the level
if the sound seems distorted.
DELAY TIME:
The delay time can be set within the range of 0 to 110 ms only
in the matrix mode.
TONE CONTROL:
This can be set individually for each surround mode except
PURE DIRECT and DIRECT.
• When making parameter settings, the display will return to the
regular condition several seconds after the last button was
pressed and the setting will be completed.
3 Press the SURROUND PARAMETER button, and
press the CURSOR D D or H H button to select the
various parameters.
5 Press the ENTER button to finish the surround
parameter mode.
4 Press the CURSOR F F or G G button to adjust the
parameter settings.
DSP surround simulation
2 To operate the surround mode and the
surround parameters from the remote control
unit
1
Select the surround mode for the input channel.
(Remote control unit)
2 Press the SURROUND PARAMETER button to
enter the surround parameter setting mode.
The surround mode switches in the following order each
time the DSP SIMULATION button is pressed:
MONO MOVIE ROCK ARENA
JAZZ CLUB MATRIX VIDEO GAME
The surround parameter switches in the following order
each time the SURROUND PARAMETER button is pressed for
the different surround modes.
2 Operating the surround mode and the
surround parameters from the main unit‘s
panel
1 Turn the SELECT knob to select the surround
mode.
When turned clockwise:
DIRECT STEREO
MONO MOVIE DTS NEO:6 5CH/7CH STEREO
MATRIX VIRTUAL SURROUND
DOLBY PRO LOGIC II x
ROCK ARENA JAZZ CLUB VIDEO GAME