Ryobi P530 - Manual (Page 12)

12
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
tool when making adjustments.
INSERTING/REMOVING BITS
See Figure 9.

Remove battery pack from speed saw.
CAUTION:
To prevent damage to the spindle or spindle lock, always
allow motor to come to a complete stop before engaging
spindle lock.
 Depress spindle lock.
 Loosen collet nut by turning counterclockwise with the
wrench provided.
WARNING:
If you are changing a bit immediately after use, be careful
not to touch the bit or collet with your hands or fingers.
They will get burned because of the heat buildup from
cutting. Always use the wrench provided.
 To insert bit: Insert shank end of bit into collet.
 To remove bit: Remove bit once collet nut is loose.
NOTE: The collet is machined to precision toler-
ances to fit bits with 1/4 in. diameter shanks. To use
bits with 1/8 in. shank bits, insert the 1/8 in. adaptor
into the 1/4 in. collet.
 Tighten collet nut securely by turning clockwise with the
wrench provided.
WARNING:
I f the collet nut is not securely tightened, t the bit may
detach during use causing serious personal injury.
 Release spindle lock.
Fig. 9
TO LOOSEN
Fig. 10
ADJUST UP OR
DOWN
TO LOOSEN
TO TIGHTEN
TO TIGHTEN
ADJUSTMENTS
WARNING:
Do not use bits with undersized shanks. Undersized
shanks will not tighten properly and could
be thrown
from the tool causing injury.
ADJUSTING DEPTH OF CUT
See Figure 10.

Remove Battery Pack From speed saw.
 Loosen adjusting knob by turning counterclockwise.
 Move depth adjustment ring to desired position.
 Tighten adjusting knob by turning clockwise.