Ryobi P530 - Manual (Page 13)

13
MAINTENANCE
WARNING:
When servicing, use only identical Ryobi replacement
parts. Use of any other parts may create a hazard or
cause product damage.
WARNING:
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
WARNING:
To avoid serious personal injury, always remove the
battery pack from the tool when cleaning or performing
any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts should
be replaced at a Ryobi Authorized Service Center.
BITS
Get faster and more accurate cutting results by keeping bits
clean. Remove all accumulated build-up from bits after each
use. Replace bits when they become dull.
CAUTION:
The bit flutes are sharp and should be handled with
caution.
COLLET
From time to time, it also becomes necessary to clean the
collet and collet nut. To do so, simply remove collet nut
and collet from the shaft and clean the dust and chips that
have collected. Then return collet nut to its original position.
Tighten collet nut on collet without a bit installed.
 Store the battery pack where the temperature is below
80°F.
 Store battery packs in a “discharged” condition.
BATTERY PACK REMOVAL AND PREPARATION
FOR RECYCLING
To preserve natural resources, please
recycle or dispose of batteries
properly.
This product uses nickel- cadmium and
lithium-ion batteries. Local, state or
federal laws may prohibit disposal of
batteries in ordinary trash.
Consult your local waste authority for
information regarding available recycling
and/or disposal options.
WARNING:
Upon removal, cover the battery pack’s terminals with
heavy-duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its compo-
nents. Lithium-ion and nickel-cadmium batteries must
be recycled or disposed of properly. Also, never touch
both terminals with metal objects and/or body parts as
short circuit may result. Keep away from children. Failure
to comply with these warnings could result in fire and/or
serious injury.
Li - Ion
BATTERIES
This product will accept Ryobi One+ 18 V lithium-ion batteriy
packs or Ryobi One+ 18 V nickel-cadmium batterry packs.
Length of service from each charging will depend on the
type of work you are doing.
The batteries for this product have been designed to provide
maximum trouble-free life. However, like all batteries, they
will eventually wear out. Do not disassemble battery pack
and attempt to replace the batteries. Handling of these
batteries, especially when wearing rings and jewelry, could
result in a serious burn.
To obtain the longest possible battery life, we suggest the
following:
For lithium-ion batteries:

Remove the battery pack from the charger once it is fully
charged and ready for use.
For battery pack storage longer than 30 days:

Store the battery pack where the temperature is below
80°F and away from moisture.
 Store battery packs in a 30%-50% charged condition.
 Every six months of storage, charge the pack as
normal.
For nickel-cadmium batteries:

Remove the battery pack from the charger once it is fully
charged and ready for use.
For battery pack storage longer than 30 days: